| |
ENGINE SPARES
Pistons, cylinders, Valves and Heads for Ural
& Dnepr
|
|
|
|
We
are always on the hunt for hard to find Ural bike spares, and
if we really can't find them,
or when the original part can be improved, we develop and make
our own alternative.
We hold £1000s of spare parts for Urals and can not list
them all, so if you need a specific part please contact us.
Ural spares are fairly easy to find and we hold a stock of most
spares.
Generally the earlier the spare, the harder it is to find. Please
note - we do not deal in used parts, or broken parts.
If we can't get it in unused new condition, we don't sell it. |
|
|
| Oil
Filters - Ural. Standard oil filter sold individually
with seal. Also in sets of three with three seals and one
O-ring. The sets of three can be ordered with the 1970s
type fibre seal for M63/M66 or with the newer rubber bush
for M67 and all 750 OHV engines. Please note these are genuine
filters, not cheaper pattern parts. |
| Part
- F20315/x1 |
£15.00 |
| Part
- F20315/x3 1970's |
£45.00 |
| Part
- F20315/x3 Late Model |
£42.00 |
|
|
|
| Barrel
Studs with Nuts - Dnepr. Set of 4 barrel studs
with 4 Dnepr special fine thread long nuts or set of 8 to
replace all the studs on both sides. |
| Part
- F20233/D4 |
£25.00 |
| Part
- F20233/D8 |
£40.00 |
|
|
|
Pistons
with Rings - Ural Russian. New flat top pistons
with rings for M63 and M66 sold in pairs only. These can
also be fitted to later 650cc Urals, but they give lower
compression than the domed pistons.
STD = 78mm, P1 = 78.20mm, P2 = 78.5 mm |
| Part
- F20402/RUS STD |
£90.00 |
| Part
- F20402/RUS P1 |
£90.00 |
| Part
- F20402/RUS P2 |
£100.00 |
|
|
|
| Pistons
with Rings - Modern Ural. These pistons will
fit Ural 650cc. They will not fit any Dneprs. Much better
piston ring system than the original 1970's type, higher
compression gives a useful increase in power without being
silly and wrecking the engine. Kit includes two pistons,
two base gaskets, two head gaskets. It does not include
gudgeon pins as it is generally better to use the ones
you have if they are the correct fit in the small end
bush. |
| Part
- F20402/650EU |
£420.00 |
|
|
|
| Pistons
& Ring - Dnepr MT11. These are genuine factory
piston. The exact measurement of the oversize piston is
not consistent or exact. As a guide, only standard is about
77.95 mm, and over-size is 78.15 mm and 78.45 mm. The rings
will need to be gapped correctly. |
| Part
- F20402/MT11 STD |
£80.00 |
| Part
- F20402/MT11 P1 |
£80.00 |
| Part
- F20402/MT11 P2 |
£85.00 |
|
|
|
Pistons Rings - Ural/Dnepr Russian. Piston ring
set to fit most OHV Urals made from 1968 to 1997 with
the four ring pistons. Fairly hard to find these days.
Standard or oversize. One set contains enough rings for
both pistons.
STD = 78mm, P1 = 78.20mm, P2 = 78.5 mm |
| Part
- F20416/RUS STD |
£26.40 |
| Part
- F20416/RUS P1 |
£26.40 |
| Part
- F20416/RUS P2 |
£26.40 |
|
|
|
| Rings
- Upgrade for Oil Rings. These fit all Dnepr OHV
engines from MT9 to MT11 and Ural M63 to M67. They only
fit the four ring pistons. The oil ring is made in three
parts and will stop oil consumption in most cases without
increasing the wear on the barrel. Only sold in sets of
2 rings, one for each piston. Replace the original oil ring
above the gudgeon pin with these upgrades. Size Standard
78.0mm or P2 78.5 mm ONLY |
| Part
- F20416/EU pair |
£30.00 |
|
|
|
| Gudgeon
Pins. Standard size or repair size. The repairs
size is useful if you have a tiny amount of play in the
small end. They are only 0.001 mm over so it will not
take out massive play caused by small end seizure. Sold
in pairs. |
| Part
- F20414/STD |
£40.80 |
| Part
- F20414/Repair |
£45.00 |
|
|
|
| Barrels
- Ural. Single barrel on its own in standard size.
We will hone the surface for you as the factory does not
bother. You will need to check your piston fit and ring
gap before riding down the road. Ural 650 barrels are iron
as shown. Ural 750 barrels are alloy. Price is each. Please
be aware that the 650 barrels are now hard to get so we
may not always be able to supply them. |
| Part
- F20502/650 |
£195.00 |
| Part
- F20502/750 |
£260.40 |
|
|
|
| Valves
- Sets. Complete set of valves. Two inlet and
two exhaust There are some traders who don't seem to know
they are different to Ural valves. Dnepr set fits MT11
only. Ural 650 set fits all Ural 650 which have different
size valves for inlet and exhaust. Ural 750 set fits all
Ural 750 OHV engines up to 2008 (pre valve stem seal models) |
| Part
- F20623/D |
£86.40 |
| Part
- F20623/U650 |
£144.00 |
| Part
- F20623/U750 |
£168.00 |
|
|
|
| Timing
Gear Overhaul Kit. For Urals 650 OHV engines only,
not Dneprs. Kit contains a matched pair of timing gears
(crank and cam) and front cover gasket, alternator gear,
tab washers, and full instructions. You will need a couple
of pullers to do this job. The 12 volt set fits M67 onwards.
We can also supply a set for the early 6 volt M63 and M66
bikes but we will not include the alternator gear. |
| Part
- F20407/6VOLT |
£96.00 |
| Part
- F20407/12VOLT |
£120.00 |
|
|
|
| Timing
Gear Overhaul Kit - European. These are fitted
as standard to new Ural 750 motorcycles from 2007 onwards.
They can be fitted to earlier 750cc OHV engines upgrade
kit. Kit contains European timing gear, European alternator
gear, tab washer. You will need to remove the cam shaft
to fit this kit. We can also machine these to fit the
650 12 volt engines. Please tell us which alternator you
have when ordering. |
| Part
- F20407/EU650 |
£264.00 |
| Part
- F20407/EU750 |
£228.00 |
|
|
|
Stainless
Steel Screw Set. Stainless steel screw set for
pre 2006 Ural front cover. Counter sunk hex drive A2 grade
set of screws to replace the standard steel flat screw.
Our set replaces all the screws in the front cover including
the two hidden behind the original coil. Ural changed to
hex drive as standard in 2006.
|
| Part
- F20206/set |
£12.00 |
|
|
|
Extra
Deep Sump - Ural. The extra deep sump is not
standard on European models. If you ride in hot conditions
this will really help. Cast aluminium with cooling fins,
holds approximately 0.75 litres more oil than the standard
aluminium deep sump fitted to European models from the
mid 1980's onward. Complete kit includes extra deep sump,
magnetic sump plug, gasket and stainless steel bolts.
|
| Part
- F20215/EXTRA |
£120.00 |
|
|
|
UK
Delivery Charges - From £7.50
Prices are per delivery not per item.
Mixed orders of many parts will normally be charged
as one large item even if it arrives in several small
boxes.
|
Small
- Small items up to about 5 kg - Max size approximately
30cm x 20cm x 12cm
Delivered to England, Scotland & Wales excluding
Scottish Highlands and Islands
|
£7.50 |
Large
- Items greater than 5kg
but less than 20kg
Delivered to England, Scotland & Wales excluding
Scottish Highlands and Islands
|
£15.00 |
Highlands
- Sorry there is no small item price for the
highlands so all deliveries up to 20 kg are one rate.
Delivered to AB30-38, AB44-56, FK17-99, G83, IV1-28,
IV30-32, IV33-39, IV52-54, IV63, KW1-14, PA21-33, PA34-40,
PH18-26, PH30, PH31-41, PH49-50
|
£15.00 |
|
|
|
